Began by taking off the rotor and began removing all the screws and putting them back with locktite, found one screw missing on the upper, I think it was on the flybar. The screw-drivers I got from X-Heli are basically crap and it did seem like the screws were glued in somewhat already.
I continued up the linkages and then re-installed the flywheel gears and then put the motor in but haven’t tightened it down, also I haven’t used locktite on all the metal to metal screws.
Set-up the Transmitter, the instructions are just a walkthrough of the menus and what they set, no explanation as to what they are or why. Also, nothing is really said about what all the switches and dials are used for.
Nothing anywhere says how the servos hook up to the receiver, found this on the web:
Chan1 Aileron – right aileron
Chan2 elevator
Chan3 throttle speed control
Chan4
Chan5
Chan6 Pitch -left aileron
Servos = orange-red-brown = signal-(positive)-(ground)
from ESC as well.
AUX – CH ? CHAN8 – THRO HLD
SWASH MIX
PIT 45
AIL 60
ELE 60